Disposal Of Batteries - Bissell 2164A SERIES User Manual

Clean the Brush
WARNING
To reduce the risk of fire, electric shock or injury, turn power OFF and disconnect from
charger before performing maintenance or troubleshooting.
1
Ensure the unit
is OFF and set
upright on a
countertop or flat
surface. Remove
the Scrubbing
Brush by lifting the
tab up and pulling
gently to release.
Clean the Window Tool
WARNING
To reduce the risk of fire, electric shock or injury, turn power OFF and disconnect from
charger before performing maintenance or troubleshooting.
1
Remove Window
Cleaning Tool by
pushing the tab upward
on the back of the unit
and pulling gently.
12
www.BISSELL.com
2
Rinse brush with clean water and check
brush for debris. Once cleaned, insert
brush by aligning the top of the brush
into the unit and snap into place. Ensure
it is secure before using.
(select models)
2
Rinse tool under water and let air dry.

Disposal of Batteries

WARNING
This product contains lithium-ion rechargeable batteries. According to
Federal and State regulations, removal and proper disposal of lithium-ion
batteries is required. For removal of the batteries in your Pet Stain Eraser,
see instructions on this page.
NOTICE: Disconnecting the battery will destroy the appliance and invalidate the
warranty.
Before proceeding, ensure that:
-the unit is disconnected from the charger
-the Clean Water Tank, Dirty Water Tank, Nozzle and brush have been removed
from unit (see removal instructions on pages 10-12)
-you have a flat-head and Phillips-head screwdriver, required for disassembly
1
Remove the cover on the base of the
unit by using a flat-head screw driver.
3
Phillips-head screwdriver
Using a ,
remove seven screws in the locations
referenced in the image.
NOTE: Keep Battery Pack together – DO NOT separate individual batteries.
For specific disposal instructions of batteries, please contact the RBRC
(Rechargeable Battery Recycling Corporation) at 1-800-822-8837
or visit www.Call2Recycle.org.
2
Remove the screw near the LED window
using a Phillips-head screwdriver. Then,
remove entire top handle portion from
unit by using a flat-head screwdriver.
4
Remove product rating label. Pull open
the housing on the base of the unit in
opposite directions. Disconnect and
remove the entire battery assembly.
www.BISSELL.com
13