Rear Panel Jacks (Depending On The Model) - Samsung HCN436W Owner's Instructions Manual

Y N T V
O U R E W

Rear Panel Jacks (Depending on the model)

Use the rear panel jacks to connect an A/V component that will be connected continu-
ously, such as a VCR or a DVD player.
Because there are two sets of input jacks, you can connect two different A/V components
(i.e., a VCR and a DVD, 2 VCRs, etc.)
For more information on connecting equipment, see pages 2.1 – 2.10.
ΠANTENNA terminals
Two independent cables or antennas can be
connected to these terminals. Use ANT-A and
ANT-B terminals to receive a signal from VHF/
UHF antennas or your cable system.
Use the ANT-A OUT terminal to send the signal
being received by the ANT-A terminal out to
another component (such as a Cable Set Top Box).
The PIP channel can be received only when
a signal source is connected to ANT-A.
´ AUDIO-VIDEO MONITOR
OUTPUT jacks
Connect to the audio/video input jacks of
a recording VCR.
Note: The monitor out does not operate
in DVD or DTV mode.
ˇ VIDEO INPUT jacks
Connect to the video output jacks of VCRs,
DVD players and similar devices (Two sets
are available: Video1 and Video2).
¨ AUDIO INPUT jacks
Connect to the audio output jacks of VCRs,
DVD players and similar devices.
ˆ S-VIDEO INPUT jack
Connect to an S-VHS VCR or DVD player.
Ø COMPONENT 1(480i, 480p,
1080i) AUDIO/VIDEO INPUT
jacks
Connect a source that outputs 480i/480p/1080i Y,P
and P signals, such as a DVD (or DTV Set-Top Box.
R
∏ DIGITAL INPUT (Digital
Visual Interface) jack
Receives the digital video signals from a set top
box. (The DVI jack is not available on PCN5425R.)
" COMPONENT 2, 3(480p,
1080i) AUDIO/VIDEO INPUT
jacks
Connect a source that outputs 480p/1080i Y,
P and P signals, such as a DTV Set-Top Box.
B R
(Component3 jacks ; Depending on the model)
' DVI AUDIO INPUT jacks
Receives the digital audio signals from a set top
box.
B
C O : Y N TV
HAPTER NE OUR EW
1.4