Samsung Network Printer User Manual page 29

5
Install a root certificate. A root certificate must be issued
by the Certificate Authority (CA) who signed the
authentication server's certificate and be in the form of
Base64 Encoded X.509 with a .cer extension. It must also
be less than 3,072 bytes.
6
Install a client certificate. A client certificate must be
issued by the trusted Certificate Authority (CA) and is used
for the RADIUS server to validate print server's identity. It
must be in the form of PKCS #12 / Personal Information
Exchange with a .pfx extension and be less than 3,072
bytes. You also need to enter the same private key
password used when a client certificate is issued by CA.
Using EAP-TTLS
1
Set Security Mode to Enhanced Security.
2
Set WPA Authentication to IEEE802.1x.
3
Set 802.1x Authentication to EAP-TLS.
4
Choose TKIP, AES, 64-bit WEP, or 128-bit WEP for
encryption. The same encryption algorithm must be
configured on the access point.
5
Choose EAP-MD5, CHAP, MS-CHAP, or MS-CHAPv2 for
inner authentication protocol. The selected inner
authentication protocol must be supported by the RADIUS
server.
6
Set an Identity name of up to 31 characters as another
identity name.
7
Set a user name of up to 31 characters. This account name
must also be set up on the RADIUS server.
8
Set a user password of up to 15 characters. This account
password must also be set up on the RADIUS server.
9
Select or deselect Enable Server Certificate Validation.
If this option is deselected, the print server always regards
the RADIUS server as a valid authentication server without
a root certificate.
10
Install a root certificate. A root certificate must be issued
by the Certificate Authority (CA) who signed the
authentication server's certificate and be in the form of
Base64 Encoded X.509 with a .cer extension. It must also
be less than 3,072 bytes. If you deselect Enable Server
Certificate Validation, you don't need to install a root
certificate.
Using PEAP
1
Set Security Mode to Enhanced Security.
2
Set WPA Authentication to IEEE802.1x.
3
Set 802.1x Authentication to EAP-TLS.
4
5
6
7
8
9
N
the print server restarts. In order to restart the print server,
from SyncThru Web Service, select Network Settings
Reset and click Restart, or turn the print server off and then
back on.
6.7
Wireless network environment
Choose TKIP, AES, 64-bit WEP, or 128-bit WEP for
encryption. The same encryption algorithm must be
configured on the access point.
Choose EAP-MD5 or MS-CHAPv2 for inner authentication
protocol. The selected inner authentication protocol must
be supported by the RADIUS server.
Set a user name of up to 31 characters. This account name
must also be set up on the RADIUS server.
Set a user password of up to 15 characters. This account
password must also be set up on the RADIUS server.
Select or deselect Enable Server Certificate Validation.
If this option is deselected, the print server always regards
the RADIUS server as a valid authentication server without
a root certificate.
Install a root certificate. A root certificate must be issued
by the Certificate Authority (CA) who signed the
authentication server's certificate and be in the form of
Base64 Encoded X.509 with a .cer extension. It must also
be less than 3,072 bytes. If you deselect Enable Server
Certificate Validation, you don't need to install a root
certificate.
: Your wireless basic setting changes will be applied after
OTE