Samsung ML ML-4050N User Manual page 51

Message Meaning
Load The paper size
specified in the
[Size] In [Tray]
printer properties
does not match the
paper you are
loading.
Load Manual The multi-purpose
Press Stop Key tray is empty in
manual feed mode.
Low Heat Error There is a problem
in the fuser unit.
Cycle Power
LSU Motor Error A problem has
occurred in the LSU
Cycle Power
(Laser Scanning
Unit).
MP Tray There is no paper in
the multi-purpose
Paper Empty
tray.
OPC is Cleaning Your printer is
printing a cleaning
sheet now.
Open Heat Error There is a problem
in the fuser unit.
Cycle Power
Out-Bin Full The output tray is
full.
Over Heat Error There is a problem
in the fuser unit.
Cycle Power
Paper Exit Jam 1 Paper has jammed
before reaching to
Open/Close Door
the exit sensor.
Suggested solutions
Load the correct
paper in the tray.
Load a sheet of print
media and press
Stop. You need to
press Stop each
page to be printed.
Unplug the power
cord and plug it back
in. If the problem
persists, please call
for service.
Unplug the power
cord and plug it back
in. If the problem
persists, please call
for service.
Load paper in the
multi-purpose tray.
See page 5.6.
Please wait a few
minutes.
Unplug the power
cord and plug it back
in. If the problem
persists, please call
for service.
It can hold up to 250
sheets of plain paper.
Once the paper is
removed from the
output tray, the
printer resumes
printing.
Unplug the power
cord and plug it back
in. If the problem
persists, please call
for service.
Clear the jam. See
page 9.3.
9.7
Message
Paper Jam 0 Paper has jammed
in the feeding area
Open/Close Door
of the tray.
Paper Jam 1 Paper has jammed
in the fuser area.
Open/Close Door
Paper Jam 2 Paper has jammed
in the paper exit
Check Inside
area.
Paper [Tray] Jam Paper has jammed
in the displayed
Open [Tray]
optional tray.
Printing... The printer is
printing jobs.
Ready The printer is on-line
and ready to print.
Self Diagnostic The LSU (Laser
LSU Scanning Unit) in
your printer is
checking some
problems detected.
Self Diagnostic The engine in your
Temperature printer is checking
some problems
detected.
Sleeping... The printer is in
power save mode.
[Tray] The displayed tray is
open.
Cassette Out
[Tray] There is no paper in
the tray.
Paper Empty
Warming Up Your printer is
Please Wait... warming up now.
<Troubleshooting>
Meaning Suggested solutions
Clear the jam. See
page 9.2.
Clear the jam. See
page 9.3.
Clear the jam. See
page 9.4.
Clear the jam. See
page 9.2.
Complete your
printing.
Use your printer.
Please wait a few
minutes.
Please wait a few
minutes.
When data is
received, it switches
to on-line
automatically.
Close the tray until it
locks into place.
Load paper in the
tray. See page 5.5.
Please wait a few
minutes.