Installation - Daewoo L1711MN User Manual

INSTALLATION

Cable Connection: VGA & DVI (optional) cable
This connection described herein applies to PC compatible with Video Graphics Array (VGA) port and
optional Digital Video Input (DVI). This also applies to any graphics video card for PC or workstation
that has a VGA connector.
1.
Before connecting, power off both the monitor and PC.
2.
Connect the VGA connector of the supplied signal cable to the output VGA connector on the PC
and the matching input connector on the rear of the LCD monitor. If your package include optional
DVI cable, connect the DVI cable to the output DVI connector from the PC and the matching input
connector to the rear of the LCD monitor.
3.
Secure the connector by tightening the thumbscrew at the connector.
4.
Connect your audio output connector on the PC to the audio input jack behind the monitor with the
supplied 3.5mm stereo speaker audio cable.
5.
Connect the supplied power adapter to the DC input jack.
6.
Connect the supplied power cable to the power adapter and plug in the supplied power cable to a
power outlet.
7.
Power ON the PC, then the monitor.
8.
If you are using Microsoft Windows Operating System, please refer to Windows driver installation
guide to proceed with software driver setup.
9.
If you see the "No signal" message, check the signal cable and connectors. Please refer to
Troubleshooting section for further instruction.
10.
After using the LCD monitor, power OFF the monitor, before turning off the PC.
Connection setup for LCD Monitor using VGA signal cable, DVI-D optional cable, 3.5 mm stereo
speaker audio cable and the connection to power supply.
6
PDF created with pdfFactory trial version
To AC
Power
Outlet
www.pdffactory.com
Audio Output