ADTRAN NetVanta Analog Modem Dial Backup Interface Module Quick Start Manual

NETVANTA ANALOG MODEM DIAL BACKUP INTERFACE MODULE (DIM)

Quick Start Guide

SLOT 1 NET/D BU
AN-DDS DBU
AN-DDS DBU
S
PECIFICATIONS
• ITU V.90 Compliant
• Async
I I
NSTALLATION NSTRUCTIONS
1. Remove power from the base unit.
2. If the Network Interface Module (NIM) is already in the
NetVanta chassis, release the pins at both edges of the
NIM faceplate and slide the module out of the chassis.
3. Carefully align the P1 connector on the NIM with the J1
connector on the analog modem DIM. Using only
fingertip pressure so that neither circuit board bends or
flexes, ensure that the connectors are firmly seated.
Secure the analog modem DIM to the NIM using the
screws and standoff posts supplied.
Quick Start Guide, 61200864L1-13B, February 2004
12 VDC
LAN
CONSOLE
POWER
Technical Support 1-888-4ADTRAN (1-888-423-8726)
For more detailed documentation, visit us online at
I I
NSTALLATION NSTRUCTIONS
4. Slide the NIM with the analog modem DIM attached
into the NetVanta option slot until the NIM is firmly
seated against the back of the chassis.
5. Secure the pins at both edges of the NIM.
6. Connect the cables to the associated device(s).
7. Complete installation of the base unit.
8. Restore power to the base unit.
A M DBU (RJ-48C) C
NALOG ODEM
Pin Name
1-3 —
4 R
5 T
6-8 —
www.adtran.com
P/N 1200864L1
(C )
ONTINUED
P
ONNECTION
Description
Unused
Network-Ring
Network-Tip
Unused
 2004 ADTRAN, All Rights Reserved
INOUT