Samsung PS-37S4A Owner's Instructions Manual page 11

Installing the Display on the Wall Attachment Panel
➢
The exterior of the PDP may be different than the picture.
(Assembly and installation of the plastic hanger is the same.)
1
Remove the screws from the back of the PDP.
2
Use the screws and assemble the plastic hanger.
3
Tighten the screws of the plastic hanger to the back side of the PDP.
4
Put the 4 pegs on the PDP in the grooves of the wall mount bracket and pull down on the PDP (!) to
secure it to the wall mount bracket (@). Tighten the screws as shown (#) so that the PDP cannot be
separated from wall mount bracket.
PDP panel
Wall attachment panel bracket
☛
◆ Please ask the installers to install the wall mount bracket.
◆ Please be sure to check if the plastic hanger is
completely secured on both the left and right side after
hanging the PDP on the wall mount bracket.
◆ Please avoid catching your fingers while installing and
adjusting the angle.
◆ Please tightly secure the wall mount bracket to the wall
to avoid injury from a falling PDP.
Wall
(continued)
11
ENG