Advertisement
8
Pedal Hub
Pedal Hub
• Turn the front wheel assembly over.
• Insert a pedal hub onto the top of the pedal axle and into
the hole in the center of the front wheel.
• Insert the remaining pedal hub below the pedal axle and
into the hole in the center of the front wheel.
9
• Push the pedal hubs into the center of the front wheel until
they are flush with the surface of the front wheel.
10
• Insert a lock washer into the slot in the pedal. Make sure
the raised tabs on the lock washer are facing the "closed"
or outside end of the pedal.
• Insert the other lock washer into the other pedal.
Assembly
11
Pedal Axle
• Place a scrap block of wood under the front wheel assembly.
• Fit a pedal on the pedal axle.
• With the lock washer centered over the pedal axle end, tap
Pedal Hubs
• Repeat this procedure to attach the other pedal to the other
12
Lock Washer
Raised Tabs
Slot
• Place the front wheel assembly between the fork arms so
• Place a fork cover over the pedal axle on one fork arm.
Closed (Outside) End
• Insert two #8 x
• Repeat this procedure to attach the other fork cover
5
the pedal with a hammer until it is secure.
end of the pedal axle.
Front Wheel Assembly
Fork Cover
Pedal Axle
that the pedal axle fits into the groove at the bottom of
each fork arm.
3
/
" screws into the fork cover and
4
tighten with a Phillips screwdriver. Do not over-tighten.
to the other fork arm.
Lock Washer
(Inside)
Pedal
Pedal Axle
Front Wheel
Assembly
Scrap Block
of Wood
Fork Arms
Groove
#8 x
3
/
" Screw – 4
4
SHOWN ACTUAL SIZE
Advertisement
