Connecting Vhf And Uhf Antennas; Antennas With 300-Ohm Flat Twin Leads - Samsung LTM1555B Owner's Instructions Manual

2
C h a p t e r 2
I
N S TA L L AT I O N

Connecting VHF and UHF Antennas

If your antenna has a set of leads that
look like this, see "Antennas with
300-ohm Flat Twin Leads," below.
If your antenna has one lead that looks
like this, see "Antennas with 75-ohm
Round Leads," on page 2.2.
If you have two antennas, see "Separate
VHF and UHF Antennas," on page 2.2.

Antennas with 300-ohm Flat Twin Leads

If you are using an off-air antenna (such as a roof antenna or "rabbit ears") that has
300-ohm twin flat leads, follow the directions below.
1
Place the wires from the
twin leads under the
screws on a 300-75 ohm
adaptor (not supplied).
Use a screwdriver to
tighten the screws.
2
Plug the adaptor into the
TV ANTENNA terminal
on the bottom of the
back panel.
2.1