Table of Contents
Advertisement
07.CHAPTER3_EN
2/5/03 12:34 AM
O
Memorizing the Channels
Your TV can memorize and store all of the available channels for both "off-air" (antenna)
and cable channels. After the available channels are memorized, use the CH
buttons to scan through the channels. This eliminates the need to change channels by
entering the channel digits. There are three steps for memorizing channels: selecting a
broadcast source, memorizing the channels (automatic) and adding and deleting channels
(manual).
Selecting the Video Signal-source
Before your television can begin memorizing the available channels, you must specify the
type of signal source that is connected to the TV (i.e., an antenna or a cable system).
1
Press the MENU button
to display the menu.
Press the DOWN
button to select
"Channel", then press
the RIGHT
2
Repeatedly press the
RIGHT
cycle through these
choices:
ANT (antenna), STD,
HRC or IRC (all cable
TV).
Note : STD, HRC and IRC identify various types of cable
At this point the signal source has been selected.
Proceed to "Storing Channels in Memory" (next page).
Page 5
P E R AT I O N
button.
button to
TV systems. Contact your local cable company to identify the
type of cable system that exists in your particular area.
and CH
3.5
C
T
: TV O
HAPTER
HREE
PERATION
Advertisement
Table of Contents
