How To Adjust Mounting Angle - Samsung HP-P5031 Owner's Instructions Manual

How to Adjust Mounting Angle

Notice : Please secure the mounting bracket on the wall surface after setting its angle at 0°.
Notice
Factory default
Please tighten the captive screw in the direction
of the arrow after assembling the bracket.
Change Angle
Connecting External Devices to the PDP
Note
• Contact an authorized technician when installing the wall attachment panel.
• After hanging the PDP panel on the wall attachment panel, make sure that the Insulation
holders are completely hung.
• Be careful not to get your fingers caught during installation.
• Make sure the wall attachment panel brackets are tightened. Otherwise, the PDP panel may
fall down.
• Please secure the mounting bracket on the wall surface after setting its angle at 0°.
How to Adjust Mounting Angle
Hold onto the middle of the PDP to adjust
the angle (not the sides of the PDP).
1 Secure the SET to the wall mount bracket.
(Please refer to the following instructions.)
Set the angle by pulling the upper end of the SET attached
2
to bracket in the direction of the arrow.
The angle can be adjusted from 0° to 15° by ±2°.
3
Be sure to remove the safety pins underneath the PDP.
1
(Caution : If the safety pins are not removed, the angle cannot
be adjusted.) Any attempt to do so may cause damage to the PDP.
2 Hold onto the bottom of the PDP and pull forward fully as
directed by the arrow(as illustrated) to adjust the angle.
(0°~20° by 2°). Insert the Safety Pins to the front guide
holes on both sides as illustrated in figure
3 Viewing the PDP after connecting the external devices.
Remove the Safety Pins to adjust the angle to 0°, and then
secure the Safety Pins again. (Warning : For safety, be sure to
secure the PDP using the safety pins. If the safety pins are not
used, the PDP may fall, causing serious injury.)
´
.
13