Controls And Connectors - Yaesu VX-150 Operating Manual

Controls & Connectors
•
ANTENNA Jack
This SMC jack accepts the supplied
ber flex antenna, or any other antenna designed to
provide 50-ohm impedance on the 2m band.
‚
VOL/OFF Control
This control adjusts the volume of the receiver. Turn
this control to the fully counterclockwise position
(into the click stop) to turn the transceiver OFF.
ƒ
DIAL Rotary Selector
This 20-position detented rotary switch tunes the
operating (or CTCSS tone) frequency or selects the memory channels, according to
which function is selected by the keys on the front panel. This knob duplicates some of
the functions of the up and down arrow keys for operating convenience.
„
SQL Control
This control sets the threshold level at which received signals (or noise) open the noise
squelch. Set this control from counterclockwise just to the point where noise is si-
lenced (and the BUSY/TX indicator on the front panel is off) when the channel is
clear.
...
BUSY/TX Indicator Lamp
This LED indicator glows green when the noise squelch is open during reception, and
red when transmitting.
†
LCD (Liquid Crystal Display)
The display shows the selected operating conditions as indicated in the following dia-
gram:
Priority Channel Scanning
Repeater Shift
Memory Mode
Memory Number
VFO Selection
Alt Key Active
2
T
OP
or
S- and TX Power Meter
LOW Power
P
ANEL
YHA-?? rub-
VX-150 O
Tone Encoder/Squelch Enabled
Digital Coded Squelch
DTMF Memory Mode
Memory Skip
BELL
Frequency
Auto Power OFF Active
LOCK Feature Active
M
PERATING ANUAL