Settings And Adjustments Before Use - JVC GY-HC900CHU Instructions Manual

Settings and Adjustments
Before Use
Attaching the Lens (Sold Separately)
This camera recorder can be attached with a B4
mount lens.
Caution :
Check that the camera recorder is turned off
0
before attaching the lens. Attaching the lens with
the power turned on can result in accident and
malfunction.
When detaching the lens, do not touch the
0
optical filter or allow dust to adhere to the optical
filter.
3
.
1 Loosen the lens lock lever.
2 Detach the body cap.
Do not lose the body cap, keep it properly.
0
3 Attach the zoom lens such that the pin
matches the hole of the mounting area.
4 Tighten the lens lock lever.
5 Connect the lens cable to the [LENS]
terminal.
6 Attach the lens cable to the clamp.
Memo :
Tighten the lens lock lever completely. If it is not
0
fully tightened, the lens may drop or the back
focus may be out of alignment.
For details on the lens, please refer to the
0
"INSTRUCTIONS" of the lens used.
It is necessary to adjust the back focus before
0
use.
(A P21 [Adjusting the Back Focus] )
14

Settings and Adjustments Before Use

Attaching the Viewfinder u v
.
1 Set the [POWER ON/OFF] switch of the
camera recorder to "OFF".
2 Loosen the viewfinder left-right position
lock ring.
3 Attach the viewfinder by sliding it in the
direction of the arrow while pulling up the
slide stopper.
1,4
.
4 Turn the viewfinder left-right position lock
ring to secure the position of the
viewfinder.
5 Attach the viewfinder cable to the [VF]
terminal.
6 Pin the viewfinder cable to the clamp.
2,4
Viewfinder
Front-Back
Position
Lock Ring
3
Slide Stopper