List Of Installer Parameters - Potterton SIRIUS THREE FS 50 Installation Manual

Tab.54 Menu Operator section
Parameter Parameter
number
24 Lighting
29 Units
40 Used as
42 Assignment device
1
43 Action operation
54 Readjustment room
sensor
70 Software version
Tab.55 Temps / mode CH1 - Temps / mode CH2 menus - Temps / mode CH3
Parameter number
Heating Heating Heating
circuit 1 circuit 2 circuit 3
714 1014 1314
720 1020 1320
730 1030 1330
732 1032 1332
740 1040 1340
741 1041 1341
7609493 - v08 - 24072018
9.1.4
Description
Off
Temporarily
Permanently
°C, bar
°F, PSI
Operator unit 1 : The control system unit is installed on the boiler.
Room unit 1 : The control system unit is configured as a room tem­
perature unit for heating circuit 1.
Room unit 2 : The control system unit is configured as a room tem­
perature unit for heating circuit 2.
Room unit 3 : The control system unit is configured as a room tem­
perature unit for heating circuit 3.
As Room Temperature Unit 1, the action of the control system unit can
be assigned to CH1 or to two heating circuits:
Temps / mode CH1
Central heating 1 and 2
Central Heating 1 and 3
All central heatings
Locally : The room temperature unit controls only the respective
heating circuit.
Centrally : Only room temperature unit 1 can be centralised. It also
controls the domestic hot water and standby mode.
-3°C to +3°C
Parameter Description
Frost protection
setpoint
Heating curve Heating curve gradient: The regulator calcu­
slope lates the flow temperature set point which is
used for the control system, according to out­
side weather conditions.
Summer/winter Limit temperature for switching between Heat­
heating limit ing/Protection mode. Triggers or shuts down
the heating in the course of the year according
to variations in outside temperature. This
switch is made automatically in Automatic
Mode.
24-hour heating The heating is shut down when the outside
limit temperature is equal to the room temperature +
parameter 732 (deactivated in Comfort mode).
Flow temp setpoint The flow set point calculated is limited by the
min set value.
Flow temp setpoint The flow set point calculated is limited by the
max set value.

List of installer parameters

9 Settings
Factory set­
ting
Temporarily
°C, bar
Operator unit
1
All central
heatings
Centrally
0°C
Unit Factory set­
ting
°C 6
– Heating
circuit 1:
1.5
Heating
circuit 2:
1.5
Heating
circuit 3:
1.5
20
°C 0
°C 25
°C 80
73