When To Change The Receipt Paper; Loading The Printer Receipt Paper - HP Engage One Retail System 143 Hardware Reference Manual

When to change the receipt paper

Change the paper when it is near the end of the roll or when the roll is empty. When the paper is low, you
must monitor usage to avoid running out part of the way through a transaction. When the roll is empty, you
must load a new roll immediately or data may be lost.
When the paper is low, a colored stripe appears on the receipt paper (if the paper purchased has a stripe)
●
indicating that enough paper remains for a small transaction.
When the roll is empty, a green LED on the printer flashes quickly indicating the paper must be installed.
●
IMPORTANT:
printer may continue to accept data from the host computer even though it is unable to print. Data may
be lost as a result.

Loading the printer receipt paper

1. Open the receipt cover by pushing up evenly on each side of the cover until it unsnaps (1).
2. Remove the test printout or used paper roll if necessary.
3. Place the receipt paper into the paper compartment on the spindle so that it unrolls from the inside (2).
Leave a few inches of paper sticking out of the printer. To prevent jamming, make sure the paper is
between the guidelines.
4. While holding the paper in place, close the receipt cover (3) making sure to apply a little more pressure
after the first click to ensure that it is fully latched. When fully latched with paper installed, the LED will
stop blinking.
Do not try to operate the printer or host computer if the printer runs out of paper. The
When to change the receipt paper 45