Connecting To A Power Source; Recording; Normal Temperature - Samsung WB500 User Manual

Connecting to a power source

You should use the rechargeable battery SLB-10A supplied with the
camera. Be sure to charge the battery before using the camera.
SLB-10A rechargeable battery Speci cation
Model
Type
Capacity
Voltage
Charging time
(When the camera is turned off)
Number of images and battery life: Using the SLB-10A
Battery life
/Number of
images
Approx. 135
MIN/
Still image
Approx. 270
shots
012
SLB-10A
Lithium Ion
1050mAh
3.7V
Approx. 150MIN
Conditions
Using the fully charged battery, Auto
mode, 10M image size, Fine image
quality, Shot to shot interval: 30sec.
Changing the zoom position between
the Wide and the Tele after every shot.
Using the ash on every second shot.
Using the camera for 5 minutes and
then Powering it off for 1 minute.

Recording

time
Approx. 125
Movie
MIN
These gures are measured under Samsung's standard conditions and
shooting conditions and may vary depending on the user's methods.
These gures are measured under OIS shooting condition.
Several videos were recorded in succession to determine the total
recording time.
Important information about battery usage.
When the camera is not used, turn off the camera power.
Please remove the battery if the camera will not be used for long
periods. Batteries can lose power over time and are prone to
leaking if kept inside the camera.
Low temperatures (below 0°C) can affect the performance of the
battery and you may experience reduced battery life.
Batteries will usually recover at normal temperatures.
During extended use of the camera, the camera body may
become warm. This is perfectly normal.
Conditions
Using the fully charged battery
640x480 image size 30fps frame rate.