Fujitsu AU*G30LRLE Design & Technical Manual page 36

CONTENTS OF FUNCTION SETTING
„ „
• Follow the instructions in the Local Setup Procedure, which is supplied with the remote control, in
accordance with the installed condition.
After the power is turned on, perform the Function Setting on the remote control.
• The settings may be selected between the following two: Function Number or Setting Value.
• Settings will not be changed if invalid numbers or setting values are selected.
1)
2)
3)
4) Vertical wind direction adjustment range
5) Cooler room temperature correction
6) Heater room temperature correction
7)
8) Indoor room temperature sensor switching function
9)
10)
11) Indoor unit fan control for energy saving
1) Filter sign
The indoor unit displays a sign to inform the user that it is time to clean the filter. Select the time
setting for the filter sign display interval in the table below according to the amount of dust or
debris in the room. If you do not wish the filter sign to be displayed, select the setting value
"No indication".
Setting Description
"Standard
(2,500 hours)"
"Long interval
(4,400 hours)"
"Short interval
(1,250 hours)"
No indication

2) Ceiling height
Select the setting values in the table below according to the height of the ceiling.
Setting Description
Standard

3.2m
High ceiling
3.6m (30 model)
4.2m (36 model)
Low ceiling
2.7m
The ceiling height values are for the 4-way outlet mode.
Do not change this setting in the 3-way outlet mode.
3) Outlet directions
Select the setting values in the table below when using a 3-way outlet.
Setting Description
4-way

3-way
Filter sign
Ceiling height
Outlet directions
Auto restart
Remote controller signal code
External input control
Function Number
11
Function Number
20
Function Number
22
- (01 - 33) -
(  . . .Factory setting)
Setting Value
00
01
02
03
(  . . .Factory setting)
Setting Value
00
01
02
(  . . .Factory setting)
Setting Value
00
01
for