Table of Contents
Advertisement
ENGLISH
How to Use the Battery Pack
Battery Pack Installation / Ejection
It is recommended to purchase one or more additional Battery Packs
to allow continuous use of your Miniket Photo.
To insert the Battery Pack
1. Push the [OPEN] switch on the
bottom side of the set in the direction
of ! as shown in the diagram and
open the lid.@
2. Insert the Battery Pack into the
battery slot until it softly clicks.
Make sure that the SAMSUNG logo
is facing up while the set is placed as
shown in the diagram.
To eject the Battery Pack
1. Push the [Battery Lock Switch] in the
direction as shown in the diagram to
pop the Battery Pack out.
2. Pull the ejected Battery Pack out in
the direction as shown in the diagram.
[ Notes ]
✤ Clean the terminals to remove any foreign substances before
inserting the Battery Pack.
✤ If the Miniket Photo will not be in use for a while, remove the
Battery Pack from the Miniket Photo.
✤ It is recommended to prepare fully charged additional Battery
Packs for outdoor use.
✤ Additional Battery Packs are available at your local Samsung
dealer and service center.
[ Warning ]
✤ When you eject the Battery Pack from the Miniket Photo, hold the
Battery Pack so as not to drop it.
20
20
如 如 何 何 使 使 用 用 電 電 池 池 組 組
安 安 裝 裝 退 退 出 出 電 電 池 池 組 組
建議舅購買一個或多個額外的電池組，這樣可連續使用舅的
<Inserting the Battery Pack>
➮
!
@
Cover
<Ejecting the Battery Pack>
➮
Battery Lock
Switch
[ 附 附 註 註 ]
✤ 在揷入電池組之前，請淸潔終端以淸除任何雜質0
✤ 若長時間不會使用
電池組0
✤ 在戶外使用時，建議舅準備好完全充電的額外電池組0
✤ 額外電池組可從舅當地的三星代理商和服務中心選購0
[ 警 警 告 告 ]
✤ 從
0
揷 揷 入 入 電 電 池 池 組 組
將裝置底部的
圖中所示的方向 ! 然後打開蓋子
@0
將電池組揷入電池槽直到輕輕賓入
到位0
當裝置如圖所示放置時，確定
退 退 出 出 電 電 池 池 組 組
將
鎖定開關）推向圖中所示的方向以
彈出電池組0
將彈出的電池組從圖中所示的方向
拉出0
退出電池組時，拿穩電池組以免掉落0
開關推向
徽標朝上0
（電池
，請取出
中的
Advertisement
Table of Contents
