Setting Up The Seating System; Pre-Set Seat Width - Sunrise Medical Quickie Q700 M SEDEO ERGO Manual

5.0 Setting up the seating system

The average wheelchair user does not exist. This is why Sunrise
Medical wheelchairs can be adjusted according to specific needs
of the user.
In this, we make a distinction between wheelchair settings and
wheelchair seating adjustment options. Settings are carried out
once, the first time the wheelchair is going to be used. They
must be executed by qualified specialist, unless explicitly stated
otherwise. Seating adjustment options can be carried out by
the user.

5.1 Pre-set seat width

Pre-set the armrest width:
• Remove the two screws (5.0mm Allen key) on the traversing
tube as shown in Fig. 5.1 - A.
• Move the armrest receiver brackets to the desired position
• Install the screws firmly prior to use.
CAUTION!
• Please check that the new arm rest position does not interfere
with any seat positioning
Pre-set the seat plate width
Lift the seat cushion off the Velcro© strips to access the seat
plates.
• Use a 5.0 mm Allen Key, (Hex Wrench).
• Adjust the seat plate width by loosening the four screws, circled
in Fig. 5.2.
Slide the plates outwards or inwards to achieve the required
•
seat width.
• The seat width is indicated by the scale that runs alongside each
slot, Fig. 5.2.
• Tighten the four screws securely.
Pre-set the back plate width
Lift the back cushion off the Velcro© strips to access the back
plate, Fig.5.3.
• Use a 5.0 mm Allen Key, (Hex Wrench).
• Loosen all of the 12 screws located within the slots.
Define the back plate width
• Slide the side plates in or out to the required width.
• Tighten the 8 screws securely (white marked in Fig. 5.3).
Positioning/centering the back plate width
• Slide the backrest to the left and the right to align with the marker pin.
• Use the measuring scale embedded on the back plates and the marker
pin for reference.
• Tighten all remaining 4 screws securely (black marked in Fig. 5.3).
• Fit a backrest cushion onto the back plate.
CAUTION!
After finishing seat width adjustments, make sure that the armrest can
be flipped up without colliding with the backrest. Not doing so can
lead to damaging the product.
 J3 Back (Fig 5.3.1):
NOTE: The Jay 3 Backrest can be used in conjunction with the Ergo
seating system. Please refer to the J3 Back Owner's Manual for
fitting and adjustment.
Q700 M Ergo Seat 13
A
Fig. 5.1
Fig. 5.2
Fig. 5.3
Fig. 5.3.1
247554 Rev. A