Selection Independent Commands; Selection Dependent Commands - Honeywell Experion LX Operator's Manual

Using faceplates
Nothing is selected if the MODE is not AUTO or MAN.
n
The system auto selects when you change the MODE using the keyboard, menu/toolbar
command, or you directly change the MODE element on the faceplate.
This behavior applies to most faceplates that have a MODE, SP, and OP element. Not all
faceplates have these elements and this auto-selection behavior may not apply. In addition,
some faceplates have elements that are considered more appropriate for auto-selection. The
auto-selection behavior of these faceplates may be customized to the requirements of your site
and operations.

Selection independent commands

You can always perform the following commands on the faceplate's current point, as long as
the faceplate has focus:
Command
Select SP
Select OP
Change mode to Manual
Change mode to Auto
Change mode to Normal
Acknowledge alarm
Silence
Point Detail
Group Display
Trend Display
Associated Page
Enable/Disable
This behavior does not vary based on the auto-selection configuration.

Selection dependent commands

The following commands require an element in the faceplate to be selected:
Command
Raise
Honeywell 2017
OEP/IKB keyboard
SP key
OUT key
MAN key
AUTO key
NORM key
ACK key
SIL key
DETAIL key
GROUP key
TREND key
ASSOC DISP key
LOAD key
OEP/IKB keyboard
RAISE key
PC keyboard
Alt+11
Alt+12
Alt+F5
Alt+F6
Alt+F7
F4
F12
F6
F7
F2
F11
PC keyboard
F9
64