Installation; Positioning The Tumble Dryer - Asko TDC111V Operating Instructions Manual

Table of Contents

Advertisement

Installation

Positioning the tumble dryer

The tumble dryer can be free-standing or in a
stack. Remember that the tumble dryer produces
heat and should therefore not be located in a room
that is too small. If the room is very small, drying
will take longer due to the limited quantity of air.
WARNING!
• Any electrical installation must be carried out
by qualified professionals.
• The machine must not be installed behind a
lockable door, a sliding door or a door with
hinges on the opposite side to those of the
tumble dryer.
• The tumble dryer's plinth ventilation must not
be blocked by a rug or the like.
NOTE!
To improve ventilation, leave the door to the
room where the tumble dryer is located open.
Freestanding
The tumble dryer can be positioned beside the
washing machine. An air gap of at least 5 mm
must be left between the washing machine and
the tumble dryer.
Stacking
The tumble dryer can be placed on top of a ASKO
washing machine. In this case, use the stacking
attachments (foot cups and anti-tilt brackets)
supplied with the machine. You will find two foot
cups in a bag in the drum and two anti-tilt brackets
are attached to the bottom left corner at the back
of the machine.
18
How to assemble the stack:
1. Undo the anti-tilt device.
2. Undo the two screws indicated on the back of
the washing machine.
3. Secure the anti-tilt device using the screws as
shown in the picture.
4. Attach the plastic cups for fixing the tumble
dryer's front feet to the washing machine's top
cover. This is essential, as only when the
tumble dryer's feet are resting in the plastic
cups can you be sure that the dryer is correctly
positioned on the washing machine.
Break off tag A on the cup fitted on the
right-hand side and tag B on the cup fitted on
the left-hand side. Then remove the paper from
the self-adhesive surface under the plastic
cups.
A
A
B
B

Advertisement

Table of Contents
loading

Table of Contents