Preparation Of Top Cabinet; Assemble And Install Adaptor; Mount The Oven - GE PVM9179, PSA9120, PSA9240 Installation Instructions Manual

A2 USE TOP CABINET TEMPLATE FOR

PREPARATION OF TOP CABINET

You need to drill holes for the top support screws,
a hole large enough for the power cord to fit through,
and a cutout large enough for the exhaust adaptor.
Read the instructions on the TOP CABINET TEMPLATE.
Tape it underneath the top cabinet.
Drill the holes, following the instructions on the TOP
CABINET TEMPLATE.
CAUTION:
drilling holes in the cabinet bottom.

ASSEMBLE AND INSTALL ADAPTOR

A3
1
Place the oven in its upright position, with the top
of the unit facing up.
2
Insert the tabs on each side of the damper into
the holes at the inside rear of the adaptor.
3 Attach the exhaust adaptor to the blower plate with
the two bronze metal screws provided.
You will need to make adjustments to assure proper
alignment with your house exhaust duct after the
oven is installed.
Installation Instructions
Wear safety goggles when
Damper
Exhaust
Adaptor
Blower Plate
Back of
Oven
A4

MOUNT THE OVEN

CAUTION:
IMPORTANT: Do not grip or use handle during
installation.
WARNING:
cause injury or death: If installing unit with metal
cord hole with the power supply cord bushing.
IMPORTANT: If filler blocks are not used, case damage
may occur from overtightening screws.
NOTE: When mounting
the microwave oven,
thread power cord through
hole in bottom of top
cabinet. Keep it tight
throughout Steps 1–3. Do
not pinch cord or lift oven
by pulling cord.
2 Rotate front of oven up
against cabinet bottom.
3
Insert a self-aligning screw through top-center
cabinet hole. Temporarily secure the oven by
turning the screw at least two full turns after
the threads have engaged. (It will be completely
tightened later.)
13
1 Lift microwave oven,
tilt it forward, and hook
slots at back bottom
edge onto four lower
tabs of mounting plate.