Connector Description; Power Supply; Dc Power Jack (Rear I/O); Table 10 Connector X42 Pinout Description - Fortec Star conga-PA3 Pico-ITX SBC Manual

5

Connector Description

5.1

Power Supply

You can power the conga-PA3 SBC with a 12 V, 5.5 x 2.5 mm laptop type DC power supply (on connector X42) or with a 2-pin power supply (on
connector X41).
Note
The supplied voltages must be within a tolerance of ± 10%. The conga-PA3 may not function if you exceed this tolerance limit.
5.1.1

DC Power Jack (Rear I/O)

The conga-PA3 SBC can be powered from a laptop type power supply connected to the DC power jack on the rear I/O. This power input offers
over-voltage and ESD protection.
Table 10 Connector X42 Pinout Description
Pin
Center Pin
Sleeve/Barrel
Connector Type
X42 : DC power jack, 5.5 x 2.5 mm diameter
Note
Revision A.x and earlier conga-PA3 industrial variants do not have DC power jack (connector X42). They are equipped with internal power
connector (X41) only.
Caution
The absolute maximum rating of the input voltage is 13.2 volts. Do not exceed this rating or expose the conga-PA3 to the absolute maximum
voltage for a prolonged time. The system may not function, may be damaged or may have reliability issues if you do not observe this warning
information.
Copyright © 2015 congatec AG
Function
+12 V
GND
DC Power Jack - Connector X42
PA3Cm11 23/81