Advertisement
Before you begin cleaning
• The steam mop and accessories get very hot during use, always allow them to cool down before handling.
• Always unplug and switch off the steam mop when assembling and fi lling water and solution tank.
• Always switch off the steam mop before emptying the water tank or changing the cleaning pads/accessories.
• IMPORTANT: Please refer to fl oor manufacturer's care recommendations before use and test the steam mop on
a discrete area of fl ooring to begin with. Check with fl ooring manufacturer for suitability on sealed fl oors prior to use.
• When using the steam mop, basic safety precautions should always be observed.
• Don't aim the steam mop at people, animals, plants and electrical components such as interior of ovens or wires.
Never touch the steam burst or fl oor head from a short distance. (There is a risk of scalding)
• The steam mop is equipped with a thermostat and a thermal cut-out. If for any reason the steam mop overheats it
will switch off . If this happens turn off and unplug the steam mop, allow to cool for a least 2 to 4 hours and re-start.
Using your machine
Place the microfibre pad
on the floor white side
facing up. Place the floor
head onto the microfibre
pad making sure it covers
the entire floor head.
Place your foot onto the
floor head and pull handle
backwards to recline.
Plug into mains and slide
switch to 'ON' position.
The blue light will illuminate
to show power on.
The green light will
illuminate to show the
steam mop is ready
to use.
To produce steam,
squeeze the trigger.
To prevent over wetting
floors avoid holding the
trigger continuously.
Using your machine
To steam your floors
without detergent select
'OFF'. This is generally
recommended for carpet
and wood flooring.
Move the steam mop
slowly backwards
and forwards paying
particular attention
to high traffic areas* .
To use with detergent
select min to max as
desired. This is generally
recommended for tile
and vinyl flooring.
*WARNING:
Never leave the
steam mop in one
spot on any surface
for an extended
period of time as
this may damage the
fl oor surface.
Hide quick links:
Advertisement
