Table of Contents
Advertisement
MagicTune™
Have you changed
doesn't work
your PC or video
properly.
graphic card?
Visit the MagicTune™ website and download the installation software for MagicTune™ MAC.
Check the following items if there is trouble with the monitor.
Check if the power cord and the video cables are properly connected to the computer.
Check if the computer beeps more than 3 times when booting.
(If it does, request an after-service for the main board of the computer.)
If you installed a new video card or if you assembled the PC, check if the installed the adaptor(video)
driver and the monitor driver.
Check if the scanning ratio of the video screen is set at 56 Hz ~ 75 Hz.
(Do not exceed 75 Hz when using the maximum resolution.)
If you have problems in installing the adaptor (video) driver, boot the computer in Safe Mode, remove
the Display adaptor at the "Control Panel → System → Device Administrator" and then reboot the
computer to reinstall the adaptor (video) driver.
If problems repeatedly occur,
Q & A
Question
How can I change the frequency?
How can I adjust the resolution?
How can I set the Power Saving function?
→ After deleting Plug and Play monitor, find 'Plug and
Play monitor' by searching new Hardware.
MagicTune™ is an additional software for the monitor.
Some graphic cards may not support your monitor.
When you have a problem with the graphic card, visit
our website to check the compatible graphic card list
provided.
http://www.samsung.com/monitor/magictune
Download the latest program. The program can be
downloaded
http://www.samsung.com/monitor/magictune
contact an authorized service
Answer
Frequency can be changed by reconfiguring the
video card.
Note that video card support can vary, depending on
the version of the driver used.
(Refer to the computer or the video card manual for
details.)
Windows XP :
Set the resolution at the Control Panel →
Appearance and Themes → Display → Settings.
Windows ME/2000 :
Set the resolution at the Control Panel → Display →
Settings.
Contact the video card manufacturer for details.
Windows XP :
Set the resolution at the Control Panel →
Appearance and Themes → Display → Screen
Saver.
Set the function at BIOS-SETUP of the computer.
Windows ME/2000 :
Set the resolution at the Control Panel → Display →
Screen Saver.
Set the function at BIOS-SETUP of the computer.
Refer to Windows/Computer Manual
center.
Advertisement
Table of Contents
