SRAM RockShox Deluxe RT3 Service Manual page 39

Use a 2 mm hex wrench to thread the bleed screw into the bleed port
7
until you feel it touch the compression ball, then tighten the bleed
screw an additional ½ turn.
Overtightening the bleed screw can damage the compression ball.
RT3: Use a shock pump with the air valve adapter tool to pressurize
8
the damper body to 350 psi.
RLR/RL/RT: Use a shock pump with the air valve adapter tool to
pressurize the damper body to 500 psi.
R: Use a shock pump with the air valve adapter tool to pressurize the
damper body to 250 psi.
If you have the proper fill equipment, you may substitute
air with nitrogen.
Once you have pressurized the shock, remove the air valve adapter
tool from the air fill port before removing it from the shock pump.
Separating the pump from the adapter first will cause all of the air to
escape from the shock.
Use a Schrader valve tool to install the damper air/nitrogen
9
fill port cap.
Remove the shock from the vise.
10
Spray the damper assembly with isopropyl alcohol and clean it with
a rag.
NOTI CE
2 mm
350 psi (RT3) 500 psi (RLR/RL/RT)
Shock Assembly and Bleed
250 psi (R)
39