Samsung SyncMaster 710NT User Manual page 87

I cannot see the On
Screen Display.
The screen shows
strange colors or just
black and white.
The screen suddenly
has become
unbalanced.
The screen is out of
focus or OSD cannot
be adjusted.
LED is blinking but no
images on the screen.
There are only 16
colors shown on the
screen.
The screen colors
have changed after
changing the video
card.
There is a message
that reads
"Unrecognized
monitor, Plug & Play
(VESA DDC) monitor
found".
There is no image on the
screen.
Is the power indicator on
the monitor blinking at 1
second intervals?
Have you locked the On
Screen Display (OSD)
Menu to prevent changes?
Is the screen displaying
only one color as if looking
at the screen through a
cellophane paper?
Have the screen colors
become strange after
running a program or due
to a crash between
applications?
Has the video card been
set properly?
Have you changed the
video card or the driver?
Have you adjusted the
resolution or frequency to
the monitor?
The screen can be unbalanced due to the cycle of the video card signals.
Readjust Position by referring to the OSD.
Have you adjusted the
resolution or frequency on
the monitor?
Is the frequency properly
adjusted when checking
the Display Timing on the
menu?
Have the Windows colors
been set properly?
Has the video card been
set properly?
Have you installed the
monitor driver?
See the video card
manual to see if the Plug
& Play (VESA DDC)
function can be supported.
disappears.
Please change to the recommended
mode during this one-minute period.
(The message is displayed again if
the system is rebooted.)
The monitor is in PowerSaver mode.
press a key on the keyboard to
activate the monitor and restore the
image on the screen.
If there is still no image, press the '
/ SOURCE ' button.
Then press any key on the keyboard
again to activate the monitor and
restore the image on the screen.
Unlock the OSD by pressing the
MENU button for at least 5 seconds.
Check the signal cable
connection.Make sure the video
card is fully inserted in it's slot.
Reboot the computer.
Set the video card by referring to the
video card manual.
Adjust screen image position and
size using the OSD.
Adjust the resolution and frequency
at the video card.
(Refer to the Preset Timing
Adjust the resolution and frequency
of the video card.
(Refer to the Preset Timing
Adjust the frequency properly by
referring to the video card manual
and the Preset Timing Modes.
(The maximum frequency per
resolution may differ from product to
product.)
Windows ME/2000/XP:
Set the colors properly at the
Control Panel → Display →
Settings .
Set the video card by referring to the
video card manual.
Install the monitor driver according
to the Driver Installation
Install the monitor driver according
to the Driver Installation
Modes).
Modes).
Instructions.
Instructions.