Table of Contents
Advertisement
Loewe klang 5 subwoofer
Operating manual
Settings directly on the Subwoofer
Settings directly on the klang 5 subwoofer
Before commencing the start-up and settings, please make sure that all cables
are connected correctly.
Status LED
Meaning of the colours of the status LED:
Blue:
DIGITAL AUDIO LINK – input active
Yellow:
WIRELESS DIGITAL AUDIO LINK – mode active
Green:
LINE IN – input active (analogue signal)
White:
no signal detected
Red:
Disorder
Status appears for ca 15 min., then the LED will turn off.
Settings via control buttons
Using several control buttons you can make various settings on the subwoofer.
The corresponding LEDs indicate the status. The LED display switches off after
ca 15 min.; when pressing one of the control buttons, the LEDs turn on again.
The handling of the settings directly on the subwoofer will depend on the con-
nection types of the subwoofer. Depending on whether the subwoofer is con-
nected via DIGITAL AUDIO LINK or LINE IN to the TV or an audio source.
When the subwoofer is connected to a Loewe TV set (chassis SL3xx and higher
versions) via DIGITAL AUDIO LINK, the POLARITY and SUBWOOFER GAIN
settings can only be made via the TV set. A local change on the klang 5 subwoo-
fer will not result in a feedback to the TV set.
When connecting the subwoofer to a TV or any audio source via LINE IN, these
settings must be made directly on the klang 5 subwoofer.
All set values remain unchanged after the subwoofer has been switched on and
off.
12
MODE settings
With the MODE button you can set the on/off behaviour of the subwoofer. The
LED indicator ON shows the selected mode. If this LED lights, the ON mode is
active. If no LED lights, AUTO ON/OFF is active.
The setting for MODE will only be made locally on the subwoofer.
Selecting AUTO ON/OFF:
By selecting AUTO ON/OFF, the subwoofer automatically switches on from
standby, when a connected TV set is switched on at the DIGITAL AUDIO LINK
IN or WIRELESS DIGITAL AUDIO LINK connector or when an audio signal is
applied at the cinch jacks LINE IN (LEFT/RIGHT).
If both connectors are simultaneously used (switched on TV set at DIGITAL
AUDIO LINK, audio source signal at LINE IN) DIGITAL AUDIO LINK has priority.
If you switch the TV set at DIGITAL AUDIO LINK to standby mode, the subwoofer
automatically switches to LINE IN.
If the TV set connected to the subwoofer at DIGITAL AUDIO LINK IN is switched
to standby, or an audio signal is not applied at LINE IN, the subwoofer in AUTO
ON/OFF mode will automatically switch off after 10 min (standby mode).
When connected to LINE IN, the subwoofer may be automatically turned on,
if we have interference signals on the audio lines (LINE IN).
When connected to LINE IN, the subwoofer can switch off automatically
during longer, very quiet periods. In this case, increase the volume.
Selecting ON:
When being in mode ON, the subwoofer will automatically switch off after 4
hours (standby mode), on the condition that the TV set connected to the sub-
woofer at DIGITAL AUDIO LINK or WIRELESS DIGITAL AUDIO LINK is switched
to standby or an audio signal is not applied at LINE IN.
POLARITY settings
With the POLARITY button you can set the phasing of the subwoofer. The two
LED indicators 0º and 180º indicate the selected setting.
Test both values (0º and 180º) and select the one with which you perceive a
clearer bass reproduction at your listening position.
When connecting the subwoofer via DIGITAL AUDIO LINK, the setting is made
in the sound components wizard (Setting of the subwoofer phase, see page
15) on the TV set.
Hide quick links:
Advertisement
Table of Contents
