Connecting The Appliance; Switching On The Appliance; Selecting The Temperature - Bosch KSL Series Operating Instructions Manual

Connecting the
appliance
After installing the appliance, wait at least
½ hour until the appliance starts up.
During transportation the oil in the
compressor may have flowed into the
refrigeration system.
Before switching on the appliance for the
first time, clean the interior (see Cleaning).
The socket should be easily accessible.
Connect the appliance to 220 240 V/
50 Hz alternating current via a correctly
installed earthed socket. The socket must
be fused with a 10 A fuse or higher.
If the appliance is to be operated in
a non European country, check on
the rating plate whether the indicated
voltage and current type correspond
to the values of your mains supply.
The rating plate is located in the
refrigerator compartment at the
bottom left hand side. The mains
connection cable may be replaced
by an electrician only.
Warning!
!
Never connect the appliance to
electronic energy saver plugs or to
power inverters which convert the
direct current to 230 V alternating
current (e.g. solar equipment, power
supplies on ships).
Switching on the
appliance
Fig. 2
Press main switch 1. Interior light comes
on, temperature indicator light flashes.
At the factory the refrigerator
compartment was set to +5 °C.
We recommend a setting of +4 °C.
Perishable food should not be stored
warmer than +4 °C.
Selecting the
temperature
The set values can be changed; see
description of the fascia.
Operating information
The temperature in the refrigerator
compartment becomes warmer:
S If the appliance door is opened
frequently
S If large amounts of food are inserted.
Condensation droplets or hoarfrost in
the refrigerator compartment
While the refrigerating unit is running,
condensation droplets or hoarfrost form
on the rear panel of the refrigerator
compartment. This is normal.
It is NOT necessary to wipe off the
condensation droplets or the hoarfrost.
The rear panel defrosts automatically. The
condensation flows into the drainage
channel Fig. 3 and is conveyed to the
refrigerating unit where it evaporates.
en
23