Page 2
Serial number: ___________________________________ Date of purchase: ________________________________ Place of purchase: ________________________________ Acer and the Acer logo are registered trademarks of Acer Incorporated. Other companies’ product names or trademarks are used herein for identification purposes only and belong to their respective companies.
Information for your safety and comrt Safety instructions Read these instructions carefully. Keep this document for future reference. Follow all warnings and instructions marked on the product. Special notes on LCD monitors The following are normal with the LCD monitor and do not indicate a problem. •...
and to protect it from overheating. These openings must not be blocked or covered. The openings should never be blocked by placing the product on a bed, sofa, rug or other similar surface. This product should never be placed near or over a radiator or heat register, or in a built-in installation unless proper ventilation is provided.
We at Acer are very conscious of the environmental effects of our business and strive to identify and provide the best working procedures to reduce the environmental impact of our products.
For more information on the Waste from Electrical and Electronics Equipment (WEEE) regulations, visit http://www.acer-group.com/public/Sustainability/ sustainability01.htm LCD pixel statement The LCD unit is produced with high-precision manufacturing techniques. Nevertheless, some pixels may occasionally misfire or appear as black or red dots.
Page 7
eyestrain. Eyes • Rest your eyes frequently. • Give your eyes regular breaks by looking away from the monitor and focusing on a istant point. • Blink frequently to keep your eyes from drying out. Display • Keep your display clean. •...
Page 8
(“x” = 0~9, a ~ z, A ~ Z, or blank) We, Acer Incorporated, hereby declare under our sole responsibility that the product described above is in conformity with the relevant Union harmonization legislations as below Directive and following harmonized...
Page 9
Acer America Corporation 333 West San Carlos St., San Jose Suite 1500 CA 95110, U. S. A. Tel : 254-298-4000 Fax : 254-298-4147 www.acer.com Federal Communications Commission Declaration of Conformity This device complies with Part 15 of the FCC Rules. Operation is subject to the following...
Table of Contents Information for your safety and comrt ................ii Safety instructions .......................ii Special notes on LCD monitors ..................ii Cleaning your monitor ..................ii Accessibility ......................ii Safe listening ......................ii Warnings ......................ii Using electrical power ..................iii Product servicing ....................iii Potentially explosive environments ..............iv Additional safety information ..................iv IT Equipment Recycling Information ................iv Disposal instructions ....................iv...
Page 11
Main Menu ....................... 13 Troubleshooting .......................18...
You can adjust the monitor’s angle from +25˚ to -5˚, and it allows 20˚ swivel adjustment from either left or right. You can also adjust the monitor’s height within +/- 130 mm. Height Adjustment 130mm Note: Please adjust the height of the monitor afer pressing the top of the monitor. Tilt X27 User Guide English...
Monitor shading hood installation Align the screw holes on the side of monitor. Use screwdriver or coin to fasten screw and fix door on the head. Repeat the same process to fix door on the other side. X27 User Guide English...
Page 16
Use fingers to push up under cover. Slide small door to the end as shown in the direction of the picture. * How to close top small door Slide small door back to the end. Push down to lock the door. X27 User Guide English...
The single toggle button on the backside of the Display bezel operates like a joystick. To move the cursor, simply toggle the button in four directions. Press the button to select desired option.Red indicates operable. Grey indicates inoperable. X27 User Guide English...
Plug the power cords of your computer and your monitor into a nearby electrical outlet. Note: • Audio output is only for audio output model. Please check user manual for more instruction. • Charging USB devices just in DC on mode. X27 User Guide English...
The power saving states will be kept until a control signal has been detected or the keyboard or mouse is activated. The recovery time from Active OFF state back to ON state is around 3 seconds. X27 User Guide English...
60Hz 3840x2160 60Hz 3840x2160 100Hz 3840x2160 120Hz 3840x2160 144Hz Note: Item 1,2,3,10 is standard timing table. Item 4,5,6,7,8,9 is PC graphic card generate timing. 11,12,13 is DP timing only. Item Item 13 is over clock timing. X27 User Guide English...
User Standard Graphics Movie Move Hot key2 (default: Brightness) Open the Brightness control and select your preferred brightness setting. When you are done, press the joystick to quit current page and store. Ref. white (nits) Adjust X27 User Guide English...
-- Off, 80%, 70%, 60%, or 50%. Note: Higher values allow more blue light through. For the best protection select a lower value. When “Blue Light” is on, Brightness & Contrast will show each level of “Blue Light” value. X27 User Guide English...
Page 25
For basic PC application (Default Setting). ECO: For saving electricity with low power consumption by providing minimum brightness for all running programs. Graphics: For better color matching representation with the graphics. Movie: For better color matching representation with the movie. X27 User Guide English...
Page 26
• Aim point: Show an Aim point on the screen for shooting games. Mode - Standard Picture Language English Color OSD Timeout Audio Transparency Off Refresh rate num Gaming Off OSD Lock Off System Move Enter • Language: Set the OSD menu language. X27 User Guide English...
Page 27
Brightness, Volume, Gamma, Contrast, Blue Light, Over Drive,PIP/PBP) Note: Hot Key 1 and Hot Key 2 can’t repeat the same function. • Quick start mode: Select Off or On. Turn on to speed up boot speed. X27 User Guide English...
Page 28
OSD menu do “overclock” to 144Hz, then reboot the monitor. • First thing to check the resolution is 3480 x 2160 @ 144Hz , Output color format is Ycbcr4:2:2 , Output color path : 10 bit • PC OS ”HDR” button select to enable. X27 User Guide English...
Page 29
Check if the video signal cable is properly connected at the back of monitor. Check if the computer system is switched on and in power saving/standby mode. Note: Acer monitor is purposed for video and visual display of information obtained from electronic devices. X27 User Guide English...