Table of Contents
Advertisement
Exploded and assembling View
7
1) Arrange SPEAKER WIRE lest should be chewed and assemble SPEAKER
BRACKET .
2) Screw 2 points marked in red circle.
10
1) Screw 4 points marked in red circle.
1) After combine SLIDE LOWER, move HINGE up and down and confirm
active state of HINGE.
8
Press CONNECTOR equally
1) After remove the whiter paper with tweezers, Insert FPCB to
connector.
2) SILK line agreement confirm certainly.
1) SILK line agreement confirm certainly.
11
1) After insert FPCB to FRONT's FPCB HOLE, Put the FRONT on slide.
2) After screw 6 points sequentially using a screwdrive, combine
3*4 KEY PAD with FRONT structure.
8-4
SAMSUNG Proprietary-Contents may change Without notice
This Document can not be used without Samsung's authorization
Fold here once so
9
that F-PCB may fold
1) Attach insulation TAPE on connector with tweezers.
2) When folded FPCB , Confirm whether become side by side with
base line
-Confirm whether become side by side with base line.
1) After insert FPCB to connect and attach TAPE, Press CONNECTOR
equally.
Remove white
12
paper
Comfirm
base line.
1) After remove white paper, Insert F-PCB to CONNECTOR.
2) When we insert FPCB, must be FPCB silk and PCB silk at one
and actuator down.
3) Press equally actuator.
1) Be careful a damage of connector.
2) Press equally actuator.
3) Silk line agreement confirm certainly.
easily.
TAPE
sticking
base line
Base line
that fold F-
PCB
Press
equally
Actuator.
Advertisement
Table of Contents
