Cooking (Lpf And Lpf-F) - BKI LPF Service Manual

Electric Pressure Fryer
3. The digital timer has a STIR OIL function that operates in one of four reconfigurable modes. If the
timer needs to be reconfigured, follow step a. If the timer does not need to be reconfigured, follow
step b.
a. Press and hold the ALARM button and at the same time place the FILTER/OFF/FRY switch
in the FRY position. The display will show the word "STIR" until the ALARM button is
released. When the button is release the display will show the current configuration mode. To
change this mode select the timer key that represents the mode you want. Refer to the table
below:
KEY DISPLAY
A
B
C
D
The display will now show the selected mode. Proceed to step c.
b. Once the fryer is filled with shortening, place the FILTER/OFF/FRY switch in the FRY
position.
c. Unless the STIR OIL function is operating in the –OFF mode, the digital timer activates a
STIR OIL function and begins an internal six minute countdown (not displayed). At the end of
the internal countdown, the display shows the words "STIR" then "OIL" in .5 second intervals
and the alarm sounds. Depress the ALARM button and stir the shortening freely while it is
heating.
IMPORTANT! Before the first cooking operation each day, stir the shortening freely while it is
heating to provide a balanced shortening temperature for excellent results with the first
cooking. Failure to do this can result in a crusty skin on the product surface with an
undercooked product internally. In addition, in some cases, failure to stir the shortening while
it is initially heating may cause the HI-LIMIT safety device to disable the power due to a false
overtemperature condition.
4. Set the thermostat to the desired cook temperature. The temperature light will go on. When the
temperature is reached, the light will go off. The light will continue to cycle on and off as the fryer
maintains the set temperature.
5. Press and hold the TIME SELECT arrow buttons on the digital timer until the desired cook time is
displayed or recall a preset time by quickly pressing the appropriate preset button.
6. The shortening will heat and begin to reach the fill mark inside the pot. Add more shortening as
required to reach the fill mark.

Cooking (LPF and LPF-F)

1. Ensure that the Start-Up procedures have been performed.
Use only high-quality shortening that has low moisture content, a high smoke
point and no additives.
New or unchanged timer. Alarm sounds at the end of the internal 6
-AL-
minute countdown.
Defeats the STIR OIL function. Timer operates as if it had no STIR
-OFF
OIL function.
PrES STIR OIL function for all Pressure Fryers.
LiFT STIR OIL function for all Autolift Fryers.
Do not open the drain valve or the fill valve while the fryer is under pressure.
Serious burns may result.
MODE DESCRIPTION
14
Operation