Service Recommendations For Hydraulic Fittings - Hitachi EX1900-5 Operator's Manual

SERVICE RECOMMENDATIONS FOR HY-
DRAULIC FITTINGS
Two hydraulic fitting designs are used on this machine.
Flat Face O-ring Seal Fitting (ORS Fitting)
An O-ring is used on the sealing surfaces to prevent oil
leakage.
1. Inspect fitting sealing surfaces (6). They must be free
of dirt or defects.
2. Replace O-ring (1) with a new one when assembling
fittings.
3. Lubricate O-ring (1) and install it into groove (3) using
petroleum jelly to hold it in place.
4. Tighten fitting (2) by hand, pressing the fitting joint to-
gether to ensure O-ring (1) remains in place and is
not damaged.
5. Tighten fitting (2) or nut (4) to the torque values shown.
Do not allow hose (5) to twist when tightening fittings.
6. Check for leaks. If oil leaks from a loose connection,
do not tighten fitting (2). Open the connection, replace
O-ring (1) and check for correct O-ring position before
tightening the connection.
Torque specifications
Width across flats (mm)
N m
Fastening
(kgf m) (9.5)
torque
(lbf ft)
MAINTENANCE
27 32 36
93 137 175
(14) (18)
(69) (101) (130)
±10%
41,46
205
(21)
(152)
7-65
2 6 1 4
6
3
5
M104-07-033