Step 9. Single Drive – Single Host SCSI Configuration
Figure 14. Single Drive-Single Host SCSI Configuration
Refer to Figure 14 and perform the following steps:
System Unit
System
Adapter
Tape Library
Backpanel
SCSI Jumper
Term inator
T
Step
1. Remove 2 screws at the bottom of the back cover and lift the cover
off the library.
Step
2. Make sure the SCSI jumper cable is installed across connectors 2
and 3 on the library back panel.
Note: With the SCSI jumper cable installed, the library is configured
as a single SCSI bus. The library and tape drive respond on
this bus.
Step
3. Make sure the terminator is installed on connector 4.
Step
4. Align the external SCSI cable with connector 1 on the library back
panel.
Step
5. Push in to seat the cable and tighten the thumbscrews (finger tight).
Step
6. Connect the other end of the SCSI cable to the system unit.
Step
7. Go to "Step 12. Connecting the Power Cables" on page 20.
System-to-Device
SCSI Cable
A
C
1
2
3
4
Chapter 2. 8mm Tape Library Installation
B
T
RSCSI01-00
17