Download Print this page
Toro TransPro 80 series Installation Instructions

Toro TransPro 80 series Installation Instructions

Transpro frame, rail ramp, flat ramp

Advertisement

Quick Links

TransPro Frame
Rail Ramp
Flat Ramp
TransPro 80
Model No. 04238—Serial No. 220000001 and Up
Model No. 04244
Model No. 04245
Mount Tongue Assembly
1. Insert tongue assembly into frame assembly while
aligning rear mounting holes (Fig. 1).
2. Secure tongue assembly into frame assembly with a
clevis pin, (2) washers and (2) cotter pins (Fig. 1).
Figure 1
1. Tongue assembly
Mount Axle and Ramp (Model 04245) or
Rail (Model 04244) Assemblies
1. Refer to figure 2 to determine which mounting holes
should be used to fit the width of your greensmower.
2
3
Figure 2
1. GR 1600 or GR 1000
w/Groomer
2003 by The Toro Company
8111 Lyndale Avenue South
Bloomington, MN 55420-1196
2
1 1
2. Frame assembly
1
2. GR 800
3. GR 1000 & Flex 21
Installation Instructions
2. Mount axle assembly and a ramp assembly (Fig. 3) or
rail assembly (Fig. ) to each end of frame with (2)
3/8–16 x 3–1/2" lg. bolts, (4) washers and (2) nuts.
Figure 3
1. Axle assembly
1
Form No. 3329–551
2
1
2. Ramp assembly (R.H.)
All Rights Reserved
Printed in the USA

Advertisement

loading

Summary of Contents for Toro TransPro 80 series

  • Page 1 Figure 2 1. GR 1600 or GR 1000 2. GR 800 w/Groomer 3. GR 1000 & Flex 21 2003 by The Toro Company 8111 Lyndale Avenue South All Rights Reserved Bloomington, MN 55420-1196 Printed in the USA...
  • Page 2 Mount/Adjust Hitch Straps Hitch straps are shipped mounted in the standard position (Fig. 6). Important Trailer tongue to be parallel to ground when aligned with tow vehicle hitch. Figure 6 1. Standard position Figure 4 1. Using one of the configurations in figure 7 or 8, adjust and secure hitch straps to trailer tongue.
  • Page 3 Mount Greensmower Wheel Assemblies 5. Engage wheel rods as follows: (Model 04244 only) On flat ramps, rotate wheel rods downward over greens mower transport wheels (Fig. 11). Note: On Greensmaster 1000 equipped with a groomer, Model 04052, the wheel shaft, on the groomer end, must be On rail ramps, lift wheel rod and rotate behind greens removed and a new wheel shaft, part no.
  • Page 4 4. Strap Greensmower to trailer when driving on rough or hilly terrain. 12. To assure optimum performance and continued safety of this product, always use genuine TORO replacement 5. The TRANSPRO 80 adds extra towing weight to the parts. Replacement parts and accessories made by other vehicle.