Register A Handset To Your Telephone Base - AT&T CL81114 User Manual

Appendix
Adding and registering handsets

Register a handset to your telephone base

1. Before you begin registration, make sure the
handset is out of the telephone base or charger
and shows To register HS, see manual.
2. Put the handset you wish to register on the
telephone base cradle.
3. The screen shows Registering... Please wait
and the light on the telephone base turns
on. If the registration is successful, HANDSET X
Registered appears on the screen (HANDSET
represents the handset name, X represents
the handset number). The handset beeps
and the light turns off. The handset is
now registered with the telephone base.
For registration, put the handset on the
telephone base, not the handset charger.
If registration fails, the system will automatically try to register
again. If registration fails after the third try, Registration failed
appears on the screen for a few seconds, and then To register
HS, see manual. This may take up to five minutes to occur. Please
start again from Step 1.
NOTE: You cannot register a handset if any other system handset is in use.
To register HS,
Registering...
Please wait
68
see manual.
HANDSET X
Registered