Philips SW9700 Manual page 25

Problem
The appliance d
oes not shave as
well as it used to.
I replaced the
shaving heads,
but the display
still shows the
replacement
reminder.
A shaving unit
symbol has
suddenly
appeared on the
display.
The notification
symbol flashes
and the shaver
beeps while the
shaver is
charging.
Possible cause
The shaving heads
are damaged or
worn.
Hairs or dirt
obstruct the shaving
heads.
You have not reset
the appliance.
This symbol
reminds you to
replace the shaving
heads.
The appliance is
overheated.
English
Solution
Replace the shaving heads
(see 'Replacement').
Clean the shaving heads in
the regular way or clean
them thoroughly.
To clean the shaving heads
thoroughly, remove the
shaving heads from the
shaving head holder one
by one (see 'Replacement').
Then separate the cutter
from its guard and rinse
each matching set under
the tap. After rinsing, place
the cutter back into its
corresponding guard.
Finally, put the shaving
heads back into the
shaving head holder (see
'Replacement').
Reset the appliance by
pressing the on/off button
for approx. 7 seconds.
Replace the shaving heads
(see 'Replacement').
Disconnect the appliance
from the wall socket for
approx. 10 minutes.
25