Table of Contents
Advertisement
2. Complete the Create New Store dialog according to the Store Information table below:
Store Information
Field Name
Name
Store#
Phone#
COM Port#
Down Load
PLUs after
Polling
Deactivate
This Store
Modem Time
Out Value
Modem Initial
String
Baud Rate
3. Click Exit to save store information.
SAM52 User's Manual
Required
/Optional
R
Enter an eight-character store name.
O
Enter a four digit number store number.
Enter the Phone number preceded by the letter T or P if
O
you intend to communicate with the register by modem.
The T is for TONE and the P is for PULSE. If you
communicate direct, leave this field blank.
Select the PC serial port (COM1- COM4) that you are
R
using for communications.
O
Enter Y if you wish to download PLUs in a polling
session. When the session is finished polling, the program
will download the PLU file.
O
Select the Deactivate This Store check box if you wish the
store to be inactive.
R
Unless otherwise indicated, the default value of 99 will be
entered automatically when the store is created
O
This field is to allow you to enter any initialization
required for your modem for polling or communications.
Do not add the command prefix "AT" in this string. If you
are using the U.S. Robotics Sportster modem, it would be
good to initialize with the string S7=60. This value makes
the modem wait for up to 60 seconds to detect a carrier. If
no carrier is detected within 60 seconds after you dial, the
modem will answer back with No Carrier Detect. Do not
put into this string any E, Q or V values. The software
automatically handles these values.
R
Select 9600, 4800, 2400, 1200, or 19,200. Be sure that the
rate set on the register (Port Settings) matches the store
information rate set here.
Description/Instructions
Menu Functions
11
Advertisement
Table of Contents
