Connecting Your Mixers - PRESONUS StudioLive 24R Networking Manual

5 Large Network: Real-world Example
5.2 Network Connections

Connecting Your Mixers

5.2.1
Changing Network Clock
Gate
-2
-12
-24
A B
FX FX
-36
-48
C D
FX FX
-65
EFFECTS MASTER MASTER CONTROL
Ch 6 Ch 7
6 7
Ch. 1
1 Voume 0.5 dB
System
System Global Lockout Audio Routing Talkback Edit
Capture Utils
Comp Gate
-2
-12
-24
A B
FX FX
-36
-48
FX C FX D
-65
Sample Rate: Permissions User Button Assgins
Network Stream
48 kHz
Network Clock:
Network Stream
Fat Ch Load/Paste Firmware
Internal
Show Peak Hold:
Off
Network Stream
LED:
Link Aux Mutes Bluetooth Reg.
Low Med High
Backlight:
Low High
A B
FX FX
FX C FX D
Sample Rate:
48 kHz
Network Clock:
Network Stream
Show Peak Hold:
Off
LED:
Low Med High
Backlight:
Low High
Connecting the three StudioLive Series III mixers to this network is relatively straight-
forward. All that needs to be done is to place the StudioLive 24R into Monitor Mixer
Mode and set the clock on the Broadcast mixer to the Network Stream, making the
mixer at Front-of-House the master clock for the system. Please note that clocking
for the StudioLive 24R is also coming from the mixer at Front-of-House. This setting
is handled automatically by the system when Monitor Mixer Mode is engaged.
Changing the network clock can be done from the System menu. To begin, press
the Home button on your StudioLive 24 broadcast mixer.
From the Home menu, press System.
TB
From the Network Clock menu, select Network Stream.
Note: The StudioLive 24 at Front-of-House must be connected to the
Network and powered on to properly distribute clock. Additionally, an
AVB stream must be connected to the Stream 1 input of the StudioLive
24 at broadcast as this is where network clock is derived.
The Clock Status indicator to the left of the selected clock source will illuminate
Green when your StudioLive mixer is properly synced.
StudioLive™ Series III
AVB Networking Guide
39