Hitachi Compute Blade 500 Installation Manual page 26

Confirm the DCB Switch's WWN
Execute show license id command to get the WWN of the DCB Switch and
(1)
write down the value in the space for "Write down here" provided below.
show license id
switch#
SwitchId LicenseId
========================================
1 10:00:00:05:1E:00:4C:80
Write down the WWN of the DCB Switch
where the license is to be installed.
The WWN of the DCB Switch is necessary to obtain the license.
Since each license only covers single DCB Switch (or WWN), if the wrong WWN is
used to obtain a license, the license may not be installed in the appropriate DCB
Switch.
Be sure to check that the WWN of the DCB Switch is correct.
3-4
Hitachi Compute Blade Embedded 10G DCB Switch Module License Installation Guide
 Enter show license id command
 Write down the value of WWN
Write down here.
Caution
Pre-confirmation