Pre-setting
To operate a DCB switch module, it is necessary to access to the DCB switch
module via the management module.
The IP address of management modules shipped from the factory is set as below.
IP address of management module
Connect the LAN interface connector of the system console and MGMT0 port of the
management module with a LAN cable. When two management modules are
installed, connect the cable to the one with MSR LED lighting up green.
2-4
Hitachi Compute Blade Embedded 10G DCB Switch Module License Installation Guide
Item
LAN cable
Compute Blade 2000
Compute Blade 500
Preparations
Factory setting
192.168.0.1
System console terminal
MSR
System console
terminal
LAN cable