<< System Console Main Menu >>
P. Start OS console session.
SW. Start switch module console session.
S. System command mode.
X. Exit.
(P,SW,S,X) : X
The following shows the disconnect procedure for Compute Blade 500.
Enter "exit" to exit from the 10G DCB switch module. And, enter "exit" to exit
from the CB500 management module.
Enter exit
sw0# exit
- Connection closed.
S0002 : Command succeeded.
S0000 : Command was finished.
Enter exit
$ exit
Enter "exit" to exit from the 10G DCB switch module. And, enter "exit" to exit
from the CB2500 management module.
Enter exit
sw0# exit
- Connection closed.
S0002 : Command succeeded.
S0000 : Command was finished.
Enter exit
(0)$ exit
2-10
Hitachi Compute Blade Embedded 10G DCB Switch Module License Installation Guide
Enter X
Compute Blade 2000
Compute Blade 500
Compute Blade 2500
Preparations