Table of Contents
Advertisement
Assembly
The machine must be fully assembled before it
can be operated. Before beginning the assembly
process, refer to Needed for Setup and gather
all listed items. To ensure the assembly process
goes smoothly, first clean any parts that are cov-
ered or coated in heavy-duty rust preventative (if
applicable).
To assemble machine:
1.
Install (4) rubber feet (see Figure 9) into
holes in bottom of legs and adjust feet so
lathe sits level without rocking.
Rubber Feet
(2 of 4)
Figure 9. Rubber feet installed.
2.
Insert end of power cord into receptacle in
back of control box (see Figure 10).
Power
Cord
Figure 10. Installing power cord.
Model G0844 (Mfd. Since 2/18)
Control Box
Test Run
Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning correctly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The Troubleshooting table in the
SERVICE section of this manual can help.
The test run consists of verifying the motor pow-
ers up and runs correctly.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
To test run machine:
1.
Clear all setup tools away from machine.
-15-
Advertisement
Table of Contents
