Table of Contents
Advertisement
2.
Slide the extension fence rods into the main
longitudinal fence, and tighten the cap screws
to hold the extension fence in place (see
Figure 14).
Figure 14. Extension fence installed.
3.
Clean any debris off the shafts of the indexing
pins, and apply a thin film of light machine oil
to the entire length.
4.
Slide the indexing pins with springs into the
holes at the ends of the boring head assem-
bly, as shown in Figure 15.
Indexing Pin
Figure 15. Indexing pin mounted in the boring
head assembly.
Model G0642 (Mfd. Since 11/14)
Boring Head
Assembly
Test Run
Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning correctly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The Troubleshooting table in the
SERVICE section of this manual can help.
The Test Run consists of verifying the following:
1) The motor powers up and runs correctly, and
2) the safety disabling mechanism on the switch
works correctly.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
To test run the machine:
1.
Make sure all tools and objects used during
set up are cleared away from the machine.
2.
If there are boring bits installed in the machine,
remove them.
3.
Make sure the boring head guard is in place
and is free to move up as the boring head
assembly comes down.
4.
Connect the machine to the power source.
-19-
Advertisement
Table of Contents
