Traditional Fireplaces Only: Install The Logs, Decorative Volcanic Stone, And Glowing Embers - Lennox ENVY Installation Instructions Manual

LENNOX HEARTH PRODUCTS • SIGNATURE
Traditional Fireplaces Only:
Install the Logs, Decorative Volcanic
Stone, and Glowing Embers
NOTE: Turn off all electricity to the appliance
before installing volcanic stone, embers and
logs.
NOTE: The log set and fire are artistically
arranged to provide an asymmetrical fire.
The fire does not burn in the left rear
quarter of the log set.
Figure 34: Log Set
1
2
6 4
NOTE: Figure 34 is representative of all
f i r e - p a r t s . c o m
fireplace models. Logs 5 and 6 may vary in
appearance from those shown above.
Table 22: Log Set
Log Number Description
1 Rear Log
2 Bottom Left Log
3 Bottom Right Log
4 Front Log
5 Top Right Log
6 Top Left Log
Catalog number for the entire set:
35 in. H8707
40 in. H8708
45 in. H8824
SERIES DIRECT-VENT GAS FIREPLACES • ENVY/ENVY CD 35/40/45 • INSTALLATION INSTRUCTIONS
®
1. Align the two holes in the bottom of
Log 1 over the two tabs at the rear of
the burner (Figure 35).
Figure 35: Placing Logs 1 and 2
3
2. Hold Log 1 in position while placing
Log 2 on the burner and resting it
against the alignment notch in Log 1
(Figure 35).
5
3. Place Log 3 in position with the
base aligned in the burner surface
(Figure 36).
Figure 36: Placing Log 3
4. Insert the left end of Log 4 under Log 3
and position the right end of Log 4 in
the notch on the top, right end of Log 3
(Figure 37).
Figure 37: Placing Log 4
5. Ensure all logs are properly positioned
on the surface of the burner and
interlocked with each other (Figure 37).
DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
1
2
3
4
6. Place Log 5 in position in the notches
on the upper right portions of Logs 1
and 3 (Figure 38).
Figure 38: Placing Logs 5 and 6
6
7. Place Log 6 in position in the notches
near the left ends of Logs 2 and 3
(Figure 38).
8. Install the volcanic stone in front of and
on the sides of the log set. Cover all of
the exposed metal floor.
5
27