Lennox ENVY Installation Instructions Manual page 24

LENNOX HEARTH PRODUCTS • SIGNATURE
Installing and initializing the Remote
Control System
Required Items (not provided):
• Standard Junction Box
• Paper Clip or similar object (for remote
control system initialization)
The receiver for the Total Comfort Control™
Remote Control System connects directly
to the gas valve, stepper motor, and fan
control module with an umbilical cord
wiring harness.
1. Install a junction box (not provided)
on the wall adjacent to the appliance,
within reach of the remote system
umbilical cord wiring harness. Position
the terminal within the junction box
in preparation for attachment to the
remote wall switch.
2. When wall finish is complete, install the
wall switch in the previously installed
junction box, and connect the terminal
to the connector on the back of the wall
switch.
3. Install the wall switch cover plate,
f i r e - p a r t s . c o m
taking care to ensure the wall switch
is properly indexed with the switch
cover when aligning the components
for attachments.
24
SERIES DIRECT-VENT GAS FIREPLACES • ENVY/ENVY CD 35/40/45 • INSTALLATION INSTRUCTIONS
®
After completing fireplace installation,
initialize the remote control system before
operating the fireplace.
1. Insert the three (3) provided AAA
batteries into the battery bay in the
transmitter. Take care to correctly align
polarity (+/–).
2. Insert the four (4) provided AA batteries
into the wall switch battery bay (behind
the wall switch plate). Take care to
correctly align polarity (+/–).
3. On the wall switch, place the three-
position slider switch in the REMOTE
position (Figure 28).
4. On the wall switch front cover, insert
the end of a paper clip (or other similar
object) into the hole marked PRG.
NOTE: The Receiver will beep three (3)
times to indicate it is ready to
synchronize with the transmitter.
5. On the transmitter, press the ON button.
The receiver will beep four (4) times to
indicate acceptance of the transmitter's
command (and set the receiver to the
transmitter's specific code). The system
is now initialized.
The remote control system provides
remote operation of the following fireplace
functions:
• Primary burner ON/OFF
• Auxiliary burner ON/OFF
• Dimmable light function
• 6-Speed blower operation
• Flame height and heat output
adjustment (six levels)
The receiver accepts commands via radio
frequency from the transmitter and does
not require line-of-sight operation.
The slider on the wall switch can be set to
one of three positions:
• ON (manual override)
• OFF (manual override)
• REMOTE (remote control)
See the fireplace Care and Operation
Instructions for detailed instructions on
using the remote control system to operate
the fireplace.
DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Figure 28: Wall Switch
Three-position slider switch
in REMOTE position
Remote
PRG
Figure 29: Transmitter (Remote Control)
LCD Display
UP/DOWN
ARROW
Key
MODE Key
WARNING
Fire hazard. Can cause severe
injury or death. The receiver
causes ignition of the appliance.
The appliance can turn on
suddenly. Keep away from
the appliance burner when
operating the remote system or
activating manual bypass of the
remote system.
CAUTION
Property damage hazard.
Excessive heat can cause
property damage. The appliance
can stay lit for many hours.
Turn off the appliance if it is
not going to be attended for any
length of time. Always place the
Transmitter where children can
not reach it.
Refer to the Appliance Care & Operations
manual (P/N 506025-01) for detailed
remote system operation instructions.
On
Off
ON/OFF Key
THERMOSTAT
Key