Canon HJ40x10B Operation Manual page 55

(C) MOUNTING THE LENS
1. Loosen the vertical adjustment lock knob, and then
lower the lens support.
2. Use the procedure below to mount the lens on the
camera.
2-1. Turn the bayonet mount of the camera counter-
clockwise, and then remove the protective cap.
2-2. Turn the dust cap on the lens counterclockwise
and then remove it.
2-3. Align the locating pin on the lens mount with the
groove on the camera mount, and then press
the lens firmly into the camera mount surface.
2-4. Turn the bayonet ring of the camera clockwise
as viewed from the lens side to secure the lens
in place.
CAUTION: In this state, the lens is only supported
by the mount section. Therefore, the
mount connection part can be damaged
by just a slight pressure. Be careful not
to apply external pressure to lens,
especially until the mounting proce-
dure is completed.
2-5. Connect the connector at the end of the lens
cable coming out from the bottom of the lens
drive unit to the camera.
3. Loosen the vertical adjustment lock knob, and also
loosen the horizontal adjustment lock knob so that
the lens support can be moved to the front or back
and up or down.
*(NOTE): 1) Be sure to also refer to the camera operation manual when performing the mounting
procedure.
2) When removing the protective cap and dust cap, be sure to keep them in a safe place
so that they do not get lost.
4. Adjust the lens support to the front or back and up or down, insert the mounting knob end screws into
the lens unit stand, and then turn the knob to secure in place.
If the positions of the mounting knob and lens unit stand are not aligned within the range where the lens
support can be adjusted forward or backward, the camera position is too far either forward or backward.
Therefore, loosen the two camera mounting screws and camera mounting lock knob, adjust the camera
position, and then tighten them to secure in place.
(For mounting procedure, see "Section 2 of 3-1. (A) MOUNTING THE SUPPORTER ON TRIPOD")
5. Once the mounting knob is secured to the lens body, tighten the vertical adjustment lock knob
and horizontal adjustment lock knob and secure in place.
Mount the lens on the camera
Horizontal Adjustment
Lock Knob
Locating Pin
Connector
E9
１×
２×
Lens Support
Mounting Knob
Vertical Adjustment
Lock Knob