Removing Excess Humidity
If the atmosphere in your room is very humid or damp, you can remove
excess humidity without lowering the room temperature too much.
1
If necessary, press the
Result:
The air conditioner starts up in the mode selected when
the unit was last used.
The unit beeps.
The air conditioner is fitted with a protection mechanism
to prevent the unit from being damaged when it is started
immediately after being:
Plugged in
Stopped
It will start up normally after three minutes.
2
If the
is not displayed at the top of the remote control, press the
button on the remote control one or more times until it appears.
Result:
The unit beeps each time you press the
The air conditioner runs in the Dry mode.
You can change modes at any time.
3
To adjust the temperature, press the
until the required temperature is displayed.
Possible temperatures are between 18°C and 30°C inclusive.
Result:
Each time you press the
- The temperature is adjusted by 1°C
- The unit beeps
The air conditioner starts removing the excess humidity;
the quantity of air is adjusted automatically.
4
To control the direction of the air flow, refer to page 20.
(On/Off) button.
buttons one or more times
buttons:
button.
15
E-