Connecting an External Device
Your Seal comes with one USB-A 3.0 port and one USB-C 3.0 port. Connect USB devices to either of the
USB ports using a USB cord. Once you plug a USB device into a USB port on your device, Windows will
automatically load a driver for that device. After the driver has been loaded once, you can disconnect and
reconnect the same device without having to install any drivers on subsequent reconnections.
Note: If Windows requires you to install the driver before connecting, check the documentation provided by
the device's manufacturer before connecting the Seal.
Disconnecting the USB port
To disconnect a USB storage device, make sure you click the Safely
Remove Hardware icon (pictured left) in the Notification Area of the
Taskbar to remove the device before disconnecting.
Note: If your USB device uses a power cord, connect the device to a power
source before connecting it.
Connecting to the HDMI Port
1.
Power OFF the external device
2.
Locate the Micro HDMI port on your Seal
3.
Connect one end of your Micro HDMI cable to the port, and the other end to
the Micro HDMI port on the external device
4.
Power on the external device; when connecting a TV, you may need to
configure your TV to external device mode
5.
Open the Settings screen, select System and then Display
6.
Tap Multiple displays to open the drop-down list
7.
From the list, select your desired monitor mode
8.
Tap Apply and confirm your settings
You can connect an external device (monitor, TV, projector, etc.)
that has a Micro HDMI port. This lets you connect your Seal to a
larger display with a higher resolution.
16