Table of Contents
Advertisement
How to Clean
1. Move the Rocker Switch to the Off position and wait for the motor to stop
completely.
2. Unplug from the wall outlet.
3. Disassemble the Juicer (see directions above)
4. Clean the Pulp Container, Pulp Chute/Juicer Cover, Food Pusher, Juice
Collector, Juice Jug and Froth Separator in warm, soapy water. A mild
detergent is recommended. Rinse well and dry thoroughly.
5. Hold the Stainless Steel Strainer Basket/Cutting Blades under clean running
water. If needed, use a small brush to gently clean away pulp from the
filter and cutting blades. Rinse under running water. Hold the Strainer
Basket/Cutting Blades up to the light to ensure that the fine mesh holes are
not blocked. If the holes are blocked, soak the Strainer Basket/Cutting
Blades in hot water to loosen the pulp and clean with the brush again.
Allow to dry on a cloth or paper towel before reassembling the juicer.
CAUTION: THE CUTTING BLADES ARE VERY SHARP.
6. Wipe the Motor Housing with a soft cloth moistened in warm soapy water.
NEVER IMMERSE MOTOR HOUSING IN WATER OR ANY OTHER LIQUID.
TROUBLESHOOTING
PROBLEM
Juicer will not operate when
switched on.
Motor stalls when juicing
Excess pulp building up in filter
Pulp too wet
Juice leaks between the rim of the
Juicer and Pulp Chute/Juicer Cover
SOLUTION
The safety locking arm may not be correctly
engaged into the 2 grooves on either side of the
Pulp Chute/Juicer Cover.
Push the Food Pusher down slowly so that wet pulp
does not build up under the Pulp Chute/Juicer
Cover. Choose Hi speed instead of Lo speed.
Alternate soft and hard fruit and vegetables
Use Lo speed. Check to be sure that the holes in
the mesh filter are not blocked. If they are blocked
follow #5 in the How to Clean section.
Use Lo speed. Fruits and vegetables with a high
water content should be juiced on Lo speed.
8
Advertisement
Table of Contents
